8CH 10M/100M PoE switch, 15.4W/channel PoE switch
1) Up to 15.4W/channel
2) High quality DC48V/1.25A power adaptor
3) 10M/100M bandwidth
5 Port 10/100Mbps Network POE power switch
4 PoE port and 1 auto-adaptable UpLink
Products Description:
POE1109 is a new generation of PoE switch which supplying power for the wireless access point of AP and network camera by using UTP CAT5e, have 8 ports of 10/100Mbps standard PoE power supply and an auto-adaptable 10/10Mbps UpLink. By using new generation of PoE management Chipsets it could be 802.3af/at compatiable by use different power adaptor. Over-voltage and under-voltage protection (Some other manufacturers' products don't support this).
Specification:
Model No. |
POE1105 |
POE1109 |
Standard |
IEEE802.3af |
|
PoE Ports |
4 PoE portst |
8 PoE ports |
Up Link Ports |
1 Up Link Port |
1 Up Link Port |
LED |
Power(red); PoE In-Use(orange); 10/100 LINK/ACT(green) |
|
Power Requirement |
100-240V AC, 50/60Hz |
|
Adapter Power Requirement |
Input: 100-240V AC, 50/60Hz, 2.0A; Output: 48V, 1.25A |
Input: 100-240V AC, 50/60Hz, 2.5A; Output: 48V, 2.5A |
Power Consumption /Dissipation |
60 Watts Max. |
120 Watts Max. |
PoE Power Output |
Per Port 48V DC, 320ma. Max. 15.4 Watts |
|
PoE Power Supply Type |
1/2(+), 3/6(-), Mode-A, End-Span |
|
PoE Power Budget |
PoE Max. 50W |
PoE Max. 110W |
Max. number of Class 3 PD |
3-Ports |
7-Ports |
Regulation Compliance |
FCC Part 15 Class A, CE |
|
Standards Compliance |
IEEE 802.3: 10Base-T IEEE 802.3u: 100Base-TX IEEE 802.3x: Flow Control IEEE 802.3ad: Port trunk with LACP IEEE 802.1D: Spanning tree protocol IEEE 802.1W: Rapid spanning tree protocol IEEE 802.1P: Class of service IEEE 802.1Q: VLAN Tagging IEEE 802.1x: Port Authentication Network Control IEEE 802.3af: Power over Ethernet |
|
Operating |
Temperature : 0~50 Degree C Relative Humidity: 20~95% |
|
Storage |
Temperature : -10~70 Degree C Relative Humidity: 20~95% (non-condensing) |
|
Dimension(WxDxH) |
116.6x83.6x27.8mm |
185x103x28mm |
Typical Application:
1) IP terminal supports PoE power supply, connecting the terminal to the PoE for electrical appliances, and canble provide DC power through transmitting data, IP terminal without laying power supply.
2) IP terminal does not support PoE power supply, the IP terminal equipment need to add a PoE splitter, the PoE splitter connected to the PoE power supply, separating the data and electricity. Through the internet to transmit data, DC power line transmits power. Seperate supply IP terminals, IP terminal without laying power supply. As shown below
Diagram